Answer
Apr 24, 2023 - 09:54 AM
Please refer to the following for the Diagnostic LED guide.
Constant illumination - No fault, normal condition
LED extinguished - Internal controller fault
1 flash - Personality out of range
2 flashes - Illegal start condition or illegal steer switch inputs (Traction)
3 flashes - Mosfet Short Circuit
4 flashes - Contactor fault or Motor Open-Circuit
5 flashes - Not used
6 flashes - Accelerator, Steer Pot or Speed Probe wire off fault
7 flashes - Low or High battery voltage or BDI cutout operating
8 flashes - Over temperature
9 flashes - Contactor coil s/c Further explanation of the LED flashes are displayed on the calibrator fault message section.
If further information is still needed, you may email us at support@cloudelectric.com.
